Converter manual

• Insert converter to the device programmer ZIF socket according to the picture placed nearby. If you have any doubts about orientation of converter in device programmer ZIF socket, there is general rule valid - the orientation of the text of converter title is the same as orientaion of the text on the top of the device programmer.
• Push the top of converter ZIF socket to open it. Insert the device into the converter ZIF socket. The right position of programmed device in converter ZIF socket is show at picture near the converter ZIF socket (commonly in above left). The reference corner of device (e.g. position of pin 1) is indicated by dot, by number 1, by bezel or by any combination of previous. Then release the top of converter ZIF socket.
• Check the interconnections between device and converter ZIF socket visually. If everything is OK, the device is ready for programming.
• Be careful - incorrect converter insertion in the device programmer ZIF socket or device insertion in the converter ZIF socket can cause the damage the programmed device.
• To take out the device push the top of converter ZIF socket and pick the device out
• When you have finished working with converter, remove it from the device programmer ZIF socket.
• Do not touch the pins of the converter and/or converter ZIF socket directly by hand. Dirty particles may cause errors during programming of the device.
• We recommend to use a acuum pick up tool  for device handling.

Accepted package(s)